Contract Board by wedi consists of a core of XPS foam reinforced on both sides with a glass fiber scrim and coated with a mortar allowing direct application of tiles.

Stocked Sizes / Pallet Quantities:

All boards measure 1300mm x 600mm in the following thickness's
- 6mm: 136 Boards
- 10mm: 100 Boards
- 12.5mm: 100 Boards

Benefits:

- suitable for indoor wall and floor application
- heat insulating
- lightweight
- pressure resistant
- bending resistant
- stable
- quick and easy to apply
- variable usable

Applications:

The XPS hard foam board is versatile due to its special properties:
- suitable for direct laying of tiles and slabs using the thin-bed method
- suitable for direct application for filler and plaster
- no primer before applying the tile adhesive needed
- can be used for indoor insulation
- is ideally suited for the wet room in combination with sealing system
- the XPS hard foam board is approved for indoor use in rooms with normal temperature

The XPS hard foam board can be processed with all commercially available tools, such as: cutter knife, hand saw, jigsaw, hand circular saw, table circular saw.

Surface requirements, laying:

The XPS hard foam board must be installed on load-bearing substrates.

XPS hard foam boards thinner than 12.5 mm:
- stud frame application not approved
- glue onto a load-bearing substrate over the entire surface (without cavities)

XPS hard foam boards with thickness ≥ 12.5 mm:
- glue or screw to load-bearing stud frame with a stud frame spacing of max. 300 mm (8 screws per XPS hard foam board)
- alternatively, glue over the entire surface

XPS hard foam boards with thickness ≥ 20 mm:
- Glue or screw to load-bearing stud frame with a stud frame spacing of max. 600 mm (8 screws per XPS hard foam board)
- alternatively, glue over the entire surface

Downloads:

Contract Board by wedi Technical Data Sheet